SIMRAD HS60 GPS Compass

The compact, standalone Simrad HS60 GPS compass provides heading, position, heave, roll and pitch information to Simrad autopilots, navigation and AIS transponder systems over an NMEA 2000® interface, and offers a single-unit replacement for both fluxgate compass and GPS receiver. 

  • Provides heading, position, heave, roll, and pitch
  • NMEA 2000® connectivity
  • 2 degree heading accuracy
  • 1 m (RMS) differential positioning accuracy
  • SBAS compatible for enhanced accuracy (WAAS, EGNOS, MSAS, etc.)
  • Accurate heading for up to 3 minutes during GPS outages
  • Small form factor

Overview

The Simrad HS60 combines a high-speed 10 Hz, SBAS-compatible GPS receiver with integrated gyro and tilt sensors to provide smooth and accurate heading, position, heave, roll, and pitch information to Simrad autopilot, navigation and AIS systems.
 
10 Hz GPS Receiver
The HS60’s high-speed GPS receiver delivers excellent in-band and out-of-band interference rejection for reliable positioning, and fast startup with ‘hot start’ in less than one second and ‘cold start’ in under a minute.
Able to acquire a heading fix in less than ten seconds under typical conditions, the HS60 offers heading accuracy of up to:
1 m RMS with differential positioning (SBAS)
3 m RMS with single-point positioning (GPS only)
Accuracy depends on environmental factors, number of satellites in view, satellite Geometry, and SBAS coverage where available.

Integrated Gyro & Tilt Sensors
Onboard gyro and tilt deliver heave, roll, and pitch information; offer faster and smoother heading updates than GPS alone; and provide heading updates during any temporary loss of GPS signal. Using these sensors, the HS60 is able to provide an accurate heading for up to three minutes during GPS outages, with an accuracy loss of no more than two degrees per minute and quick reacquisition of position once signal has resumed.
NMEA 2000® Connectivity
The HS60 connects via NMEA 2000® to Simrad AP70 and AP80 autopilot systems, and to GN70, MX610, and MX612 navigation systems. A single NMEA 2000® bus connection is required, standard cable with 5-pin micro connector sold separately.
 
Small Form Factor, Simple Installation
The compact and lightweight HS60 is supplied as a standalone system including mounting accessories. With GPS receiver, gyro and tilt sensors, and all other electronics integrated into the IP69 water-resistant antenna enclosure, there is no ‘black box’ required below deck.

Specification

Technical/Environmental

Product Length [mm]

259 mm / 10.2 in

Operating Temperature

-30 °C to +70 °C (-22 °F to +158 °F)

Operating Temperature Stored

-40 °C to +85 °C (-40 °F to +185 °F)

Product Width

129 mm / 5.1 in

Product Height

45 mm / 1.8 in

Product Weight

0.42 kg / 0.9 lb

Other

Humidity Range [rh]

100% non-condensing

Compass Safe Distance [mm]

300

Information

Picth/Roll Angle

2° (RMS)

Power

Power Consumption

2.0 W nominal

Power Supply (Supply Voltage)

8 to 36 VDC

Grounding

Isolated to enclosure

Reverse Polarity Protection

Yes

Communications

Baud Rates

4800, 9600, 19200, 38400, 57600, 115200

Correction I/O Protocol

RTCM SC-104

Data I/O Protocol

NMEA 2000

Serial Ports

1 NMEA 2000

GPS Navigation

Heading Accuracy

2° (RMS)

Heading Fix

< 10s typical (valid position)

Rate of Turn

90°/s maximum

Receiver Type

GPS L1 Compass

Networking Connectors

Connectors

NMEA 2000 Connector: 5 Pin Male Micro Connector

 

Documents

Request an Offer



3 + 1 = ?